Warmland PS45 Classic Series A Owner's Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
PELLET STOVES 16 PS45 CLASSIC 151211-24
Cleaning the Flue Gas Passages
Cleaning the  ue gas passage should be done at least once a
year or every one to two tons of pellets used.(50-100 bags)
Burning high ash pellets may require this cleaning to be done
more often.
Clean this passage only when the stove and ash are cold.
Cleaning the Firebox Passage:
Remove the Burn-Pot and Liner as per previous cleaning section,
and use an appropriate vacuum cleaner to remove the loosened
ash from the  rebox. Push on the top of the brick – this will kick
out the bottom edge. Pull the bottom of the Fire Brick towards
you. Drop the brick down once it clears the ledge.
Fig. #14
Fig. #15
Cabinet Side
Screws
Using a ratchet with a 3/8” socket, remove the screws on both
sides of the Firebox Liner Fig.#16 Remove the Liner from the
rebox. Using a  ltered shop vacuum, clean out all the ash in
the exhaust passages (Fig #17).
Fig. #16
Don’t forget to clean up around the heat exchanger. Once the  ue
passage is clear of ash build-up, reinstall the Firebox Liner.
Fig. #17
Firebox Passage -
Clean through here
Cleaning the Vent Pipe
Soot and Flyash – Formation and Need for Removal: The
products of combustion will contain small particles of  yash
and/or soot. The Flyash and/or soot will collect in the exhaust
venting system and restrict the  ow of the  ue gases. The exhaust
venting system should be inspected at least once every year to
determine if cleaning is necessary. Sweep the pipe as needed.
A tee and clean-out in the vent system at the transition from
horizontal to vertical will make this cleaning easier.
Paci c Energy Fireplace Products recommends
having your stove inspected and cleaned by a
trained professional
Cabinet Side Removal
Remove the two screws holding the back of the Cabinet Side
to the chassis. Lift up slightly to disengage the screws at the
front and pull off. Installation is the reverse.
Firebox liner
screw
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments