Warmland PS45 Classic Series A Owner's Manual download pdf (Page 18)

PELLET STOVES 18 PS45 CLASSIC 151211-24

Component Information

The following is a list of other components and their

functions.

Igniter

The Warmland PS45 stove comes equipped with an automatic

igniter for lighting the fuel when the stove is in the lighting mode.

The igniter superheats air that is pulled through the Burn-Pot

by the combustion blower to light the fuel. The igniter remains

energized for the  rst 10 minutes of the lighting sequence.

Vacuum Switch

The stove has a Vacuum Switch, located on the right rear hopper

leg. If the pressure drops in the  rebox due to a leak, a blocked

 ue, open front door or unsealed ashdrawer, the vacuum switch

will sense this and open the circuit to the Auger Motor. The stove

will then go into a shutdown mode.

Auger and Auger Motor

A 1 rpm gearmotor turns the Auger, lifting pellets up the

augertube. The pellets are then dropped down a tube and into

the burn-pot. The auger is controlled by the control board.

HIGH LIMIT Snap Switch (Manual Reset)

This switch is installed on the convection blower duct and shuts

the stove down if it senses excessive temperatures (Opens

at 200° F). This snap switch has a reset button on it and will

not allow the stove to start up until the reset button has been

pushed.

Proof of Fire Snap Switch

This switch is installed on the combustion blower and is used to

sense when there is a  re in the stove during Start-Up. It will shut

the stove off if it senses there is no  re in the Fire-Pot Liner.

Draft Damper

The Warmland PS45 Classic stove has a draft damper located

at the left side of the stove directly in front of the combustion

blower. After the stove is installed the Draft Damper will need

to be set for the vent con guration. With the stove hot, use a

magnehelic gauge to adjust the slider until a reading of .15" is

achieved in the  rebox. The sampling hole is located in the top

of the ash box, above the ashpan. To reduce the draft, move

the adjuster toward the center of the stove.

Burn-Pot Mixer Motor

This 1 RPM gear motor turns the Burn-Pot Mixer rod via a

coupling and chain drive system.

The Mixer Motor is controlled by the control board.

Fig. #20

CLOSED

OPEN

DAMPER: FACTORY

SET, FLUSH WITH

FIREBOX SIDE.

Hopper Switch

The hopper switch is located on the back of the hopper. It is

activated by the arms of the hopper lid. If the hopper is left open

it will cut power to the auger motor, the  re will go out and the

stove will go into shutdown mode. The #3, head output light

will also be  ashing.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Warmland PS45 Classic Series A Owner's Manual Page 18

Comments to this Manuals