Warmland PS45 Classic Series A Owner's Manual download pdf (Page 14)

PELLET STOVES 14 PS45 CLASSIC 151211-24

Inspection /cleaning weekly monthly yearly

Ash Pan - Leg Model X or Every 15 bags of fuel burned

Burn-Pot X or Every 5 bags of fuel burned

Burn-Pot Liner X or more frequently depending on fuel quality

Blower - Convection X or more frequently if pets present

Blower - Exhaust X or more frequently depending on fuel quality

Firebox X or more frequently depending on fuel quality

Heat Exchanger X or more frequently depending on fuel quality

Venting system X more frequently depending on fuel quality

Glass X or if viewing area becomes completely obstructed

Door Seals/Gaskets X Replace if damaged

CAUTION: INSTALLATION AND REPAIR SHOULD

ONLY BE PERFORMED BY A QUALIFIED SERVICE

TECHNICIAN. DO NOT ATTEMPT TO SERVICE

THE APPLIANCE YOURSELF.

IMPORTANT CAUTIONS:

• SHUT DOWN THE STOVE AND UNPLUG POWER

CORD TO ENSURE APPLIANCE IS COLD BEFORE

PERFORMING ANY MAINTENANCE WORK.

• Some brands of pellets produce more ash and clinkers than

others. Therefore the frequency of performing the following

cleaning procedures depends to a great degree on the type

of pellets burned.

• Not cleaning this unit will cause it to burn poorly and will void

your warranty for this appliance.

• A cleaning brush can be used to loosen any ash build-up

before vacuuming.

***DO NOT USE A STANDARD HOUSEHOLD VACUUM.

WHEN USING A SHOP VACUUM, A FINE DUST FILTER

MUST BE INSTALLED. AS THE STANDARD FILTERS

WILL LEAK THE FINE PARTICLES OF ASH INTO THE

HOME. DEPENDING ON THE SYSTEM, USE CAUTION

AS SOME DUST MAY STILL PASS THROUGH THE

VACUUM.***

***DO NOT VACUUM HOT ASH!***

• Using a drop cloth is recommended as some ash may spill

onto the  oor during the cleaning process

Burn-Pot and Liner Cleaning

The Burn-Pot Liner has a number of holes in the bottom and

sides that provide combustion air to the pellets. The extreme

temperatures in the Burn-Pot can cause the impurities in the

pellets to form ash and clinkers.

The rotating Burn-Pot mixer is designed to clean and move spent

ash out of the Burn-Pot Liner. However, some grades of pellets

may slowly restrict the holes in the Liner. The liner should be

inspected periodically to ensure the holes are clear.

Burn-Pot Mixer

Coupling

Burn-Pot Liner

Fig. #10

The Burn-Pot (cradle the Liner sits in) should be emptied after

burning about 10 - 15 bags of pellets.

When the stove is cool, open the door and remove the Burn-Pot

Grate, push it back to release the tabs, then lift up. Disengage

the cleaner bar by rotating it until the pin on the end is free of

the coupler. Then slide the cleaner left and up. Once it clears

the liner, pull to the right to free the other end.

Routine Checks and Maintenance

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Comments to this Manuals

No comments

Warmland PS45 Classic Series A Owner's Manual Page 14

Comments to this Manuals