Warmland PS45 Classic Series A Owner's Manual download pdf (Page 12)

PELLET STOVES 12 PS45 CLASSIC 151211-24

Thermostat installation

The Warmland PS45 Classic stove can be operated manually

or by a thermostat. The stove comes from the factory in the

manual mode. To operate in the two "Thermostat" modes a

low voltage thermostat must be installed. Consult dealer for

appropriate thermostat.

To install the thermostat:

1) Unplug the stove from the electrical outlet. Open the right

cabinet side (page 16, Fig #14) and remove the 2 screws holding

the main board to the side of the hopper. (see Fig. #7)

Operation

Filling the Hopper

The hopper can be accessed by lifting the hopper lid in the

top. Check for any foreign objects in the hopper before  lling

with pellets.

Control Board

The control board regulates all functions of the stove. The controls

are located on the top near the back of the unit.

2) Locate the double screw terminal wiring block at the top of

the board, (Fig. #8) loosen the two screws on the block. Insert

one of the wires from the thermostat into one of the slots and

tighten the screw. Repeat this process for the other thermostat

wire.

See Page 13 for thermostat operation modes.

IMPORTANT NOTE: Follow the Thermostat manufacturers

installation and set-up instructions. Failure to follow

manufacturers instructions could result in a malfunction. Pay

special attention to the thermostat location requirements. If

the location requirements are not followed, the appliance may

operate erratically or failure may occur.

Do not mount the thermostat where it may be affected by:

• Radiant heat from the stove, sun or other heat sources.

• Drafts or dead spots behind doors or in corners.

• Hot or cold air from ducts.

The following is a list of the board’s controls:

• POWER light - Is red during start-up, switching to green when

the stove is  nished the start-up sequence. Flashes when the

auger is feeding pellets into the Burn-Pot.

• ON/OFF Button - Is pushed to start the stove, and to turn the

auger off and start the shut down sequence.

• HEAT LEVEL Buttons - LOW is pushed to reduce the heat

output. It is also used to reduce the values of the "trim" settings.

HIGH is pushed to increase the heat output setting. It is also

used to increase the values of the "trim" settings.

• AUGER TRIM - Used with the high/low buttons to trim the

auger timing pulses when the pellet quality/size requires more

or less fuel to burn properly.

• EXHAUST TRIM - Can be used with the high/low buttons to

adjust the combustion blower speed to compensate for changes

to air/fuel ratio.

• MAN-HI/LO-AUTO - Thermostat mode selector switch. The

slide switch is used to select the desired thermostat mode. (See

"Thermostat Operation" on page 13)

Thermostat

Screw Terminal

Fig. #7

Fig. #8

Fig. #9

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Comments to this Manuals

No comments

Warmland PS45 Classic Series A Owner's Manual Page 12

Comments to this Manuals